
Requires 3.1.71 firmware or later
----------------------------------
The included Sync scripts play one video named on the master
and the slaves. For synchronization, we recommend using transport
streams (either mpeg2 or h.264) because they open faster and play
more efficiently.


Sync Signal
------------
With these scripts, the master waits 10 seconds after bootup, waiting for
the slave unit to startup. The master units ends a preload signal to the
slaves telling them to preload the video. The master then sends a second
signal 100ms later telling the slaves to play the video. This is repeated
each time the video plays. 


IP Address
When synchronizing over Ethernet, you don't need to set the IP address
of the slave units. If there's no DHCP present, we recommend setting the address manually. If you have more than 2 units, please adjust the IP address of the slave script on each unit so the units don't have the smae IP 
address. So, if slave1 is 192.168.0.11, then slave 2 would be 192.168.0.12.



Ethernet Cable
If you are connecting two units together using Ethernet, you can use a 
standard Ethernet cable. No crossover cable or hub/switch is required.